SANJUKS V7

Example shown: Gold body, black acetal capsule grip, and Mid Collar. Your product will match the options selected when ordering.

Body Colors · 2 Choices

Acetal Capsule Grips · 2 Choices

01. Compare the Mounting Holes

The V7 uses an MJ multi-mounting plate. Compare the plate dimensions and hole positions in the drawing below with your enclosure. Matching screw holes alone are not enough if the collar or lower components interfere with the case.

Mounting plate drawing · Dimensions in mm

02. Allow Space Beyond the Body Height

The listed body height is approximately 36 mm, excluding the grip, shaft, and collar. The stated measurement may vary by approximately 2–3 mm. Allow additional space for the lower shaft, actuator, switch terminals, and wiring.

03. Using 5-Pin Wiring? Prepare a Conversion Harness

The V7 uses an 8-terminal connection to individual microswitches. If your fightstick uses a 5-pin connector, you will need a compatible 5-pin to 8-terminal conversion harness. Check both your PCB's pinout and the switch terminal size.

Included Components

The photo illustrates the component set. Body color, grip color, and collar height are supplied according to your selected options.

Hyper Grommet and V7-Specific Bobbin

The V7 uses a dedicated bobbin matched to the Hyper grommet for the Knee Lever. Before transferring a grommet or bobbin from another lever, check that the combination is compatible with the V7. Replacement grommets must also be compatible with the V7-specific bobbin.

How the Circular Guide Feels

The stock circular guide allows the lever to follow a rounded path at the edge of its travel. The clicking sound comes from the microswitches actuating. The guide shape and the points at which the switches register inputs are separate aspects of the lever's feel.

Change One Component at a Time

Some components are shared with the V6, but not all parts use the same dimensions. When choosing a shaft, guide, or actuator, check its V7 compatibility and dimensions. Changing one component at a time makes it easier to understand how each change affects the feel.

Start with the Stock Setup

First, get familiar with the return-to-center feel, diagonal inputs, and how different grip positions affect your control. Feel can vary with grommet wear, component combinations, and personal preference.

STEP 01

Record the Existing Setup

Disconnect your fightstick's USB cable and power before opening the case. Take photos of the existing lever orientation, wiring, and screw positions to help with reassembly and input checks.

STEP 02

Check Collar Clearance and Mounting Points

Confirm that the selected Full Collar or Mid Collar clears the top panel. Before securing the mounting plate, check that there is enough room for the lower shaft and wiring. Do not force parts into holes or mounting points that do not fit.

STEP 03

Secure the Grip and Lower Components

Hold the shaft's wrench flats with the 8 mm wrench while tightening the capsule grip. Check that the actuator is correctly assembled and that the E-Clip is fully seated in the shaft groove. The wrench holds the shaft steady while you tighten the grip.

STEP 04

Connect the Wiring and Test Every Direction

Connect the switch terminals without stretching or pinching the wires. Remove your hands and tools from the case, then reconnect power. Use an input test screen or practice mode to check up, down, left, right, diagonals, and neutral. Once everything works correctly, disconnect power again and close the bottom panel.

If a Direction Registers in Reverse

Disconnect power, then check your wiring photos and PCB pinout to correct the signal connection for the affected direction. Identify the common ground and directional signal wires rather than relying on wire colors alone. Check the connections before attempting to bend any microswitch levers.